2008 Mazda 3
Mileage
211,105
Service Date
7/29/2026
Services Performed
- Smog Car Or Truck 2000+
- tire pressure check
Sam R. gave our service a 5 star review on 7/29/2026
-
-
2014 Mazda 3
Mileage133,580Service Date5/14/2026Services Performed- Smog Car Or Truck 2000+
- Full Vehicle Inspection
Cyrus B. gave our service a 5 star review on 5/15/2026 -
2018 Mazda 3
Mileage48,976Service Date3/31/2026Services Performed- Smog Car Or Truck 2000+
- tire pressure check front 35 rear 35
Cheryl S. gave our service a 5 star review on 3/31/2026 -
2018 Mazda CX-9
Mileage65,940Service Date3/5/2026Services Performed- Smog Car Or Truck 2000+
- tire pressure check front 35 rear 35
Charlie S. gave our service a 5 star review on 3/5/2026 -
2012 Mazda 3
Mileage220,314Service Date2/26/2026Services Performed- Smog Car Or Truck 2000+
- tire pressure check front 32 rear 32
Steve H. gave our service a 5 star review on 2/27/2026 -
2014 Mazda CX-5
Mileage229,718Service Date1/30/2026Services Performed- Full Vehicle Inspection
- Remove and replace front brake pads
- Oil change – remove and replace filter
- Courtesy vehicle inspection.
- Hazardous Waste Oil Fee
- VALVE COVER GASKET – Remove & Replace
- tire pressure check front 36 rear 36
Krista T. gave our service a 5 star review on 2/5/2026 -
2012 Mazda 3
Mileage143,611Service Date1/27/2026Services Performed- Diagnose transmission issue and traction control light on
- Transmission Module Software Update
- TRANSAXLE OIL PAN GASKET – Remove & Replace – 6 Spd Trans
- tire pressure check front 35 rear 35
Manuel T. gave our service a 5 star review on 1/27/2026 -
2013 Mazda 3
Mileage118,102Service Date1/23/2026Services Performed- Removed door trim and attached power probe with back probe pin to power wire at lock switch. found 4.4 volts unloaded .when locking the voltage goes to 2.1 volts and works consistently so the switch provides resistance. When unlocking the voltage is not changing. Squeezing the switch hard makes it actuate and voltage goes to zero. When ground is applied the circuit works consistently. Recommend replace door lock switch.
- Oil change – remove and replace filter
- Hazardous Waste Oil Fee
- Rotate Tires
- Courtesy vehicle inspection.
- Before service the discharge pressure is at 200psi which is very high considering ambient temp is 50 degrees. Suction side pressure is ok at 30 psi and center vent temperature is 40 degrees which is an excellent target temperature. Customer states performance is poor. With excessive high side pressure the failure is likely occurring at much higher ambient temperature causing the discharge pressure to increase to a point that the evaporator cant function. Recommend replace expansion valve to regain control of discharge pressure.
- EVAPORATOR EXPANSION VALVE – Remove & Replace – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
- Diagnose master door switch not unlocking or locking doors
- DOOR LOCK SWITCH – Remove & Replace – Front left
- Remove and replace rear brake pads and rotors
- Remove and replace battery
- tire pressure check front 32 rear 32
Cyrus B. gave our service a 5 star review on 1/24/2026 -
2008 Mazda 3
Mileage194,179Service Date8/19/2025Services Performed- Smog Car Or Truck 2000+
- tire pressure check front 32 rear 32
Kelsey M. gave our service a 5 star review on 8/19/2025 -
2017 Mazda MX-5 Miata
Mileage67,461Service Date6/18/2025Services Performed- Smog Car Or Truck 2000+
Alan C. gave our service a 5 star review on 6/18/2025
